Currently, rxdma1_enable and supports_monitor are set to false in IPQ5332 hardware parameters, which skips monitor ring configuration and removes NL80211_IFTYPE_MONITOR from the supported interface modes. Set rxdma1_enable and supports_monitor to true so that monitor rings are configured and monitor mode is enabled on IPQ5332. Tested-on: IPQ5332 hw1.0 AHB WLAN.WBE.1.7-00587-QCAHKSWPL_SILICONZ-1 Signed-off-by: Aaradhana Sahu --- drivers/net/wireless/ath/ath12k/wifi7/hw.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/wireless/ath/ath12k/wifi7/hw.c b/drivers/net/wireless/ath/ath12k/wifi7/hw.c index df045ddf42da..27acdfc35459 100644 --- a/drivers/net/wireless/ath/ath12k/wifi7/hw.c +++ b/drivers/net/wireless/ath/ath12k/wifi7/hw.c @@ -617,7 +617,7 @@ static const struct ath12k_hw_params ath12k_wifi7_hw_params[] = { ath12k_wifi7_target_service_to_ce_map_wlan_ipq5332, .svc_to_ce_map_len = 18, - .rxdma1_enable = false, + .rxdma1_enable = true, .num_rxdma_per_pdev = 1, .num_rxdma_dst_ring = 0, .rx_mac_buf_ring = false, @@ -626,7 +626,7 @@ static const struct ath12k_hw_params ath12k_wifi7_hw_params[] = { .interface_modes = BIT(NL80211_IFTYPE_STATION) | BIT(NL80211_IFTYPE_AP) | BIT(NL80211_IFTYPE_MESH_POINT), - .supports_monitor = false, + .supports_monitor = true, .idle_ps = false, .download_calib = true, base-commit: 20ad0d58517073b3b683ff786c65dd3142321707 -- 2.34.1