6.18-stable review patch. If anyone has any objections, please let me know. ------------------ From: Sebastien Royen commit fc13ba44da197a186f2f4d77c5b7d73d0f99f053 upstream. The KSZ8765 is similar to the KSZ8795 but has two fiber ports. KSZ8_PORT_STATUS_0 is used to detect fiber mode. It is currently defined as 0x08, which is the Global Control 6 MIB Control register and has bit 7 defined as Flush Counter. Set KSZ8_PORT_STATUS_0 to 0x18, which is the Port 1 Status 0 register where bit 7 is the Fiber Mode bit. This issue was discovered when upgrading an embedded device from kernel 5.10 to 6.16. The device was using a KSZ8765 device tree configuration and the corresponding hardware, but during boot the kernel incorrectly detected it as a KSZ8795. The relevant boot messages were: ksz-switch spi0.0: found switch: KSZ8795, rev 0 ksz-switch spi0.0: Device tree specifies chip KSZ8765 but found KSZ8795, please fix it! Cc: stable@vger.kernel.org Fixes: 91a98917a883 ("net: dsa: microchip: move switch chip_id detection to ksz_common") Reviewed-by: Nicolai Buchwitz Signed-off-by: Sebastien Royen Link: https://patch.msgid.link/20261007080557.15719-1-sebastien.royen@armadeus.com Signed-off-by: Jakub Kicinski Signed-off-by: Greg Kroah-Hartman --- drivers/net/dsa/microchip/ksz_common.h | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) --- a/drivers/net/dsa/microchip/ksz_common.h +++ b/drivers/net/dsa/microchip/ksz_common.h @@ -775,7 +775,7 @@ static inline bool ksz_is_sgmii_port(str #define KSZ88_FAMILY_ID 0x88 #define KSZ8895_FAMILY_ID 0x95 -#define KSZ8_PORT_STATUS_0 0x08 +#define KSZ8_PORT_STATUS_0 0x18 #define KSZ8_PORT_FIBER_MODE BIT(7) #define SW_CHIP_ID_M GENMASK(7, 4)