Currently the dp83867 supports setting the io impedance to minimum, maximum, default or a value from a nvmem cell. In situations where there is no backend for a nvmem cell, the value can not be set to anything but minimum, maximum or default. Add support for the ti,output-impedance binding, allowing to specify the impedance via the devicetree. The existing boolean bindings for minimum and maximum take precedence over this new binding. The nvmem consumer still takes lowest precedence. Signed-off-by: Steffen Trumtrar --- drivers/net/phy/dp83867.c | 13 ++++++++++--- 1 file changed, 10 insertions(+), 3 deletions(-) diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c index 88255e92b4cdb..e98c5d940410e 100644 --- a/drivers/net/phy/dp83867.c +++ b/drivers/net/phy/dp83867.c @@ -542,12 +542,19 @@ static int dp83867_of_init_io_impedance(struct phy_device *phydev) "failed to get nvmem cell io_impedance_ctrl\n"); /* If no nvmem cell, check for the boolean properties. */ - if (of_property_read_bool(of_node, "ti,max-output-impedance")) + if (of_property_read_bool(of_node, "ti,max-output-impedance")) { dp83867->io_impedance = DP83867_IO_MUX_CFG_IO_IMPEDANCE_MAX; - else if (of_property_read_bool(of_node, "ti,min-output-impedance")) + } else if (of_property_read_bool(of_node, "ti,min-output-impedance")) { dp83867->io_impedance = DP83867_IO_MUX_CFG_IO_IMPEDANCE_MIN; - else + } else if (of_property_read_u32(of_node, "ti,output-impedance", &val)) { + if ((val & DP83867_IO_MUX_CFG_IO_IMPEDANCE_MASK) != val) { + phydev_err(phydev, "'ti,output-impedance' contents out of range\n"); + return -ERANGE; + } + dp83867->io_impedance = val; + } else { dp83867->io_impedance = -1; /* leave at default */ + } return 0; } -- 2.54.0