Replace rio_probe1() printk(KERN_INFO) messages with netdev_{info,dbg}(). Keep one netdev_info() line for device identification; move the rest to netdev_dbg() to avoid spamming the kernel log. Log rx_timeout on a separate line since netdev_*() prefixes each message and the multi-line formatting looks broken otherwise. No functional change intended. Tested-on: D-Link DGE-550T Rev-A3 Signed-off-by: Yeounsu Moon --- Changelog: v2: - Keep one netdev_inf() line; switch the rest to netdev_dbg() v1: https://lore.kernel.org/netdev/20260104111849.10790-2-yyyynoom@gmail.com/ --- drivers/net/ethernet/dlink/dl2k.c | 17 +++++++---------- 1 file changed, 7 insertions(+), 10 deletions(-) diff --git a/drivers/net/ethernet/dlink/dl2k.c b/drivers/net/ethernet/dlink/dl2k.c index 846d58c769ea..69bfb8265d57 100644 --- a/drivers/net/ethernet/dlink/dl2k.c +++ b/drivers/net/ethernet/dlink/dl2k.c @@ -279,18 +279,15 @@ rio_probe1 (struct pci_dev *pdev, const struct pci_device_id *ent) card_idx++; - printk (KERN_INFO "%s: %s, %pM, IRQ %d\n", - dev->name, np->name, dev->dev_addr, irq); + netdev_info(dev, "%s, %pM, IRQ %d", np->name, dev->dev_addr, irq); if (tx_coalesce > 1) - printk(KERN_INFO "tx_coalesce:\t%d packets\n", - tx_coalesce); - if (np->coalesce) - printk(KERN_INFO - "rx_coalesce:\t%d packets\n" - "rx_timeout: \t%d ns\n", - np->rx_coalesce, np->rx_timeout*640); + netdev_dbg(dev, "tx_coalesce:\t%d packets", tx_coalesce); + if (np->coalesce) { + netdev_dbg(dev, "rx_coalesce:\t%d packets", np->rx_coalesce); + netdev_dbg(dev, "rx_timeout: \t%d ns", np->rx_timeout * 640); + } if (np->vlan) - printk(KERN_INFO "vlan(id):\t%d\n", np->vlan); + netdev_dbg(dev, "vlan(id):\t%d", np->vlan); return 0; err_out_unmap_rx: -- 2.52.0