The board carries a Realtek RTL8211F gigabit PHY on the external management bus, connected to the MAC over RGMII. Enable the controller, hand it the ethernet pins and point it at the PHY. RGMII needs a delay on each of its two clocks. The board traces add none, so the PHY adds both, which is what rgmii-id asks of it. The PHY interrupt output is wired to GPIOH_6, so link changes are reported instead of polled. The PHY reset is an RC network on the board, not a SoC pin, so there is no reset line to describe. Assisted-by: LLM Signed-off-by: Lucas Tanure --- .../amlogic/amlogic-t7-a311d2-khadas-vim4.dts | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) diff --git a/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts b/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts index 0fa83362b417..4914b0dff8a8 100644 --- a/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts +++ b/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts @@ -14,6 +14,7 @@ / { compatible = "khadas,vim4", "amlogic,a311d2", "amlogic,t7"; aliases { + ethernet0 = ðmac; serial0 = &uart_a; mmc0 = &sd_emmc_c; mmc1 = &sd_emmc_b; @@ -256,6 +257,24 @@ xtal: xtal-clk { }; }; +ðmac { + status = "okay"; + pinctrl-0 = <ð_pins>, <ð_rgmii_pins>; + pinctrl-names = "default"; + phy-mode = "rgmii-id"; + phy-handle = <&external_phy>; +}; + +&ext_mdio { + external_phy: ethernet-phy@0 { + /* Realtek RTL8211FD-CG */ + reg = <0>; + + interrupt-parent = <&gpio_intc>; + interrupts = ; + }; +}; + &i2c_m_ao_a { status = "okay"; pinctrl-0 = <&i2c0_ao_d_pins>; -- 2.56.0