From: Tomasz Unger Fix spelling mistakes in comment block (lines 64, 69, 72): - 'recieves' -> 'receives' - 'recieving' -> 'receiving' - 'recived' -> 'received' Found by manual inspection. Signed-off-by: Tomasz Unger --- drivers/nfc/trf7970a.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/nfc/trf7970a.c b/drivers/nfc/trf7970a.c index d17c701c7888..c3bf48f49eca 100644 --- a/drivers/nfc/trf7970a.c +++ b/drivers/nfc/trf7970a.c @@ -61,15 +61,15 @@ * support that. So, if an abort is received before trf7970a_send_cmd() * has sent the command to the tag, it simply returns -ECANCELED. If the * command has already been sent to the tag, then the driver continues - * normally and recieves the response data (or error) but just before + * normally and receives the response data (or error) but just before * sending the data upstream, it frees the rx_skb and sends -ECANCELED * upstream instead. If the command failed, that error will be sent * upstream. * - * When recieving data from a tag and the interrupt status register has + * When receiving data from a tag and the interrupt status register has * only the SRX bit set, it means that all of the data has been received * (once what's in the fifo has been read). However, depending on timing - * an interrupt status with only the SRX bit set may not be recived. In + * an interrupt status with only the SRX bit set may not be received. In * those cases, the timeout mechanism is used to wait 20 ms in case more * data arrives. After 20 ms, it is assumed that all of the data has been * received and the accumulated rx data is sent upstream. The -- 2.53.0