The usbnet driver currently relies on fixed transmit queue lengths, which can lead to bufferbloat and large latency spikes under load - particularly with cellular modems. This patch adds support for Byte Queue Limits (BQL) to dynamically manage the transmit queue size and reduce latency without sacrificing throughput. Testing was performed on various devices using the usbnet driver for packet transmission: - DELOCK 66045: USB3 to 2.5 GbE adapter (ax88179_178a) - DELOCK 61969: USB2 to 1 GbE adapter (asix) - Quectel RM520: 5G modem (qmi_wwan) - USB2 Android tethering (cdc_ncm) No performance degradation was observed for iperf3 TCP or UDP traffic, while latency for a prioritized ping application was significantly reduced. For example, using the USB3 to 2.5 GbE adapter, which was fully utilized by iperf3 UDP traffic, the prioritized ping was improved from 1.6 ms to 0.6 ms. With the same setup but with a 100 Mbit/s Ethernet connection, the prioritized ping was improved from 35 ms to 5 ms. Signed-off-by: Simon Schippers --- drivers/net/usb/usbnet.c | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/drivers/net/usb/usbnet.c b/drivers/net/usb/usbnet.c index 62a85dbad31a..1994f03a78ad 100644 --- a/drivers/net/usb/usbnet.c +++ b/drivers/net/usb/usbnet.c @@ -831,6 +831,7 @@ int usbnet_stop(struct net_device *net) clear_bit(EVENT_DEV_OPEN, &dev->flags); netif_stop_queue (net); + netdev_reset_queue(net); netif_info(dev, ifdown, dev->net, "stop stats: rx/tx %lu/%lu, errs %lu/%lu\n", @@ -939,6 +940,7 @@ int usbnet_open(struct net_device *net) } set_bit(EVENT_DEV_OPEN, &dev->flags); + netdev_reset_queue(net); netif_start_queue (net); netif_info(dev, ifup, dev->net, "open: enable queueing (rx %d, tx %d) mtu %d %s framing\n", @@ -1500,6 +1502,7 @@ netdev_tx_t usbnet_start_xmit(struct sk_buff *skb, struct net_device *net) case 0: netif_trans_update(net); __usbnet_queue_skb(&dev->txq, skb, tx_start); + netdev_sent_queue(net, skb->len); if (dev->txq.qlen >= TX_QLEN (dev)) netif_stop_queue (net); } @@ -1563,6 +1566,7 @@ static inline void usb_free_skb(struct sk_buff *skb) static void usbnet_bh(struct timer_list *t) { struct usbnet *dev = timer_container_of(dev, t, delay); + unsigned int bytes_compl = 0, pkts_compl = 0; struct sk_buff *skb; struct skb_data *entry; @@ -1574,6 +1578,8 @@ static void usbnet_bh(struct timer_list *t) usb_free_skb(skb); continue; case tx_done: + bytes_compl += skb->len; + pkts_compl++; kfree(entry->urb->sg); fallthrough; case rx_cleanup: @@ -1584,6 +1590,8 @@ static void usbnet_bh(struct timer_list *t) } } + netdev_completed_queue(dev->net, pkts_compl, bytes_compl); + /* restart RX again after disabling due to high error rate */ clear_bit(EVENT_RX_KILL, &dev->flags); -- 2.43.0