The YT8531 needs a 25 MHz reference. On boards without a local crystal it is fed from the SoC, described as a clock on the PHY node. Get and enable it in probe so the PHY is clocked before its registers are accessed. The clock is optional, so crystal-clocked boards are unaffected. Signed-off-by: Jiaxing Hu --- This supersedes "[PATCH net-next v2] net: stmmac: dwmac-rk: ..." which enabled the clock on the MAC side; Andrew and Maxime rightly pointed out that the PHY is the consumer and should enable it. That series is dropped. The DTS that consumes this (rk3576-armsom-cm5) goes to the rockchip tree separately; the clock is optional so this patch stands alone. Tested on an ArmSoM CM5-IO: the YT8531 links at 1000 Mbit/s. drivers/net/phy/motorcomm.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/drivers/net/phy/motorcomm.c b/drivers/net/phy/motorcomm.c index 708491bc1..2f85974a3 100644 --- a/drivers/net/phy/motorcomm.c +++ b/drivers/net/phy/motorcomm.c @@ -6,6 +6,7 @@ * Author: Frank */ +#include #include #include #include @@ -1169,9 +1170,20 @@ static int yt8521_probe(struct phy_device *phydev) static int yt8531_probe(struct phy_device *phydev) { struct device *dev = &phydev->mdio.dev; + struct clk *clk; u16 mask, val; u32 freq; + /* + * A crystal-less YT8531 takes its 25 MHz reference from the SoC. When + * that reference is described as a clock, enable it for the life of the + * device. It is optional, so crystal-clocked boards are unaffected. + */ + clk = devm_clk_get_optional_enabled(dev, NULL); + if (IS_ERR(clk)) + return dev_err_probe(dev, PTR_ERR(clk), + "failed to get and enable the reference clock\n"); + if (device_property_read_u32(dev, "motorcomm,clk-out-frequency-hz", &freq)) freq = YTPHY_DTS_OUTPUT_CLK_DIS; -- 2.43.0