Commit a274465cc3be ("net: phy: support 'active-high' property for PHY LEDs") added PHY_LED_ACTIVE_HIGH and made of_phy_led() set the matching bit in the modes mask when a LED node carries the 'active-high' property. dp83867 was not part of that series. dp83867_led_polarity_set() only recognizes PHY_LED_ACTIVE_LOW, so PHY_LED_ACTIVE_HIGH falls through to the default case and returns -EINVAL. of_phy_led() propagates the error, of_phy_leds() drops the LEDs registered so far and passes it on, and phy_probe() returns it. A device tree marking a DP83867 LED as 'active-high', which leds/common.yaml allows and ethernet-phy.yaml references for led@N nodes, thus leaves the mdio device unbound, so phy_attach_direct() falls back to the genphy driver: the PHY comes up without its DP83867 configuration and loses the RGMII internal delay setup. Active high is what the function programs when no polarity mode is requested at all, so the initial value of polarity already satisfies the request and only the case label is missing. Cc: stable@vger.kernel.org Fixes: a274465cc3be ("net: phy: support 'active-high' property for PHY LEDs") Assisted-by: Claude:claude-fable-5 Signed-off-by: Donggeun Yoo --- drivers/net/phy/dp83867.c | 3 +++ 1 file changed, 3 insertions(+) diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c index 88255e92b4cd..61a941aa02d9 100644 --- a/drivers/net/phy/dp83867.c +++ b/drivers/net/phy/dp83867.c @@ -1150,6 +1150,9 @@ static int dp83867_led_polarity_set(struct phy_device *phydev, int index, case PHY_LED_ACTIVE_LOW: polarity = 0; break; + case PHY_LED_ACTIVE_HIGH: + polarity = DP83867_LED_POLARITY(index); + break; default: return -EINVAL; } -- 2.53.0