From: Shiji Yang Date: Sat, 28 Mar 2026 23:29:56 +0800 There are hardware defects in the MT7621 (MT7530) EEE support: with EEE advertised, some link partners cannot establish a stable connection. Notably, on a 2-pair (4-wire) cable where both ends advertise gigabit, 1000BASE-T training cannot succeed, and instead of falling back to 100 Mbps the port flaps in a loop and no link/DHCP lease is obtained. This is confined to the WAN / phylib bring-up path; the DSA/LAN side on the same device is unaffected. The MT7530 internal GE PHY advertises EEE by hardware default. The eee-broken-100tx / eee-broken-1000t device-tree properties only take effect during the late PHY config_init path, which is too late for these link partners: they negotiate EEE before the OS disables it and then fail to fall back cleanly. Commit af3b4b0e59de ("net: phy: mediatek-ge: do not disable EEE advertisement") removed the early EEE-advertisement disable from mtk_gephy_config_init(), on the rationale that "disabling EEE advertisement before the PHY driver initialises keeps it off", i.e. that the DSA subdriver already performs that early disable. That rationale holds for MT7531, whose mt7531_setup() clears MDIO_AN_EEE_ADV on each switch PHY -- but it does not hold for MT7621, whose mt7530_setup() never had such a loop. So af3b4b0e59de removed the only early EEE disable that covered MT7621, reintroducing the flapping on MT7621-based boards (regression reported on ramips/mt7621). MediaTek's own recommendation (Landen Chao, 2021) confirms the hardware is the root cause: "EEE of the 10-year-old MT7530 internal gephy has many IOT problems, so it is recommended to disable its EEE." Restore the early disable for MT7621, but on the DSA side -- exactly the location af3b4b0e59de assumed it already lived -- by clearing MDIO_AN_EEE_ADV on each switch PHY in mt7530_setup(), guarded on priv->id == ID_MT7621, mirroring the existing mt7531_setup() loop. Auto-negotiation then falls back to a stable 100 Mbps link instead of hanging at gigabit. Tested on ASUS RT-AX53U (MT7621): a single clean "Link is Up - 100Mbps/Full - flow control off" + DHCP lease on a 2-pair cable, where the unpatched driver loops. Confirmed on kernel 6.12 and 6.18; also confirmed on Netgear R6220 and EdgeRouter-X (both MT7621). Fixes: af3b4b0e59de ("net: phy: mediatek-ge: do not disable EEE advertisement") Signed-off-by: Shiji Yang Signed-off-by: Vladislav Karmanov --- drivers/net/dsa/mt7530.c | 9 +++++++++ 1 file changed, 9 insertions(+) --- a/drivers/net/dsa/mt7530.c +++ b/drivers/net/dsa/mt7530.c @@ -2518,6 +2518,15 @@ if ((val & MT7530_XTAL_MASK) == MT7530_XTAL_40MHZ) mt7530_pll_setup(priv); + if (priv->id == ID_MT7621) { + /* Disable EEE advertisement on the switch PHYs. */ + for (i = MT753X_CTRL_PHY_ADDR(priv->mdiodev->addr); + i < MT753X_CTRL_PHY_ADDR(priv->mdiodev->addr) + MT7530_NUM_PHYS; + i++) { + mt7530_phy_write_c45(priv, i, MDIO_MMD_AN, MDIO_AN_EEE_ADV, 0); + } + } + mt753x_trap_frames(priv); /* Enable and reset MIB counters */