According to FW documentation, the most time-consuming FW operation is Shadow RAM (SR) dump which takes up to 3.2 seconds. For X550 family devices the module-update FW command can take over 4.5 s. The default semaphore loop runs 200 iterations with a 5 ms sleep each, giving a maximum wait of 1 s -- not "200 ms" as previously stated in error. This is insufficient for X550 family FW update operations and causes spurious EBUSY failures. Extend the SW/FW semaphore timeout from 1 s to 5 s (1000 iterations x 5 ms) for all three X550 variants: ixgbe_mac_X550, ixgbe_mac_X550EM_x, and ixgbe_mac_x550em_a. All three share the same FW and exhibit the same worst-case latency. Use three explicit mac.type comparisons rather than a range check so future MAC additions are not inadvertently captured. The timeout variable is set immediately before the loop so the intent is clear, with an inline comment stating the resulting maximum delay. Fixes: 030eaece2d77 ("ixgbe: Add x550 SW/FW semaphore support") Suggested-by: Soumen Karmakar Suggested-by: Marta Plantykow Cc: stable@vger.kernel.org Signed-off-by: Aleksandr Loktionov Reviewed-by: Simon Horman Reviewed-by: Jacob Keller --- v2 -> v3: - Add Reviewed-by: Simon Horman, Reviewed-by: Jacob Keller; no code change (Jacob suggested read_poll_timeout() but accepted as-is). v1 -> v2: - Squash with 0015 (X550EM extension); fix commit message ("200ms" was wrong, actual default is 1 s); replace >= / <= range check with three explicit mac.type == comparisons per Tony Nguyen. drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c index e67e2fe..a3c8f51 100644 --- a/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c +++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c @@ -577,6 +577,15 @@ int ixgbe_acquire_swfw_sync_X540(struct ixgbe_hw *hw, u32 mask) swmask |= swi2c_mask; fwmask |= swi2c_mask << 2; + /* Extend to 5 s (1000 x 5 ms) for X550 family; default is 1 s + * (200 x 5 ms). FW SR-dump takes up to 3.2 s; module-update up + * to 4.5 s. + */ + if (hw->mac.type == ixgbe_mac_X550 || + hw->mac.type == ixgbe_mac_X550EM_x || + hw->mac.type == ixgbe_mac_x550em_a) + timeout = 1000; + for (i = 0; i < timeout; i++) { /* SW NVM semaphore bit is used for access to all * SW_FW_SYNC bits (not just NVM) -- 2.52.0