The MT8189 SoC has in the Ethernet control 0 register from the peripheral configuration (pericfg) an additional bit to enable the TX clock signal output. In preparation of MT8189 SoC support, add its definition, use in the mt8195_set_interface callback, and a support flag in the platform data. Signed-off-by: Louis-Alexis Eyraud --- drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c index 6123efbbaf02..36599dc33b14 100644 --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-mediatek.c @@ -36,6 +36,9 @@ #define ETH_FINE_DLY_GTXC BIT(1) #define ETH_FINE_DLY_RXC BIT(0) +/* Peri Configuration register for mt8189 */ +#define MT8189_CTRL0_TXC_OUT_OP_EN BIT(20) + /* Peri Configuration register for mt8195 */ #define MT8195_PERI_ETH_CTRL_OFFSET 0xFD0 @@ -109,6 +112,7 @@ struct mediatek_dwmac_variant { u16 rx_delay_stage_div; u16 tx_delay_stage_div; u8 dma_bit_mask; + bool mac_txclk_out_en; }; /* list of clocks required for mac */ @@ -302,6 +306,9 @@ static int mt8195_set_interface(struct mediatek_dwmac_plat_data *plat, /* MT8195 only support external PHY */ intf_val |= MT8195_EXT_PHY_MODE; + if (plat->variant->mac_txclk_out_en) + intf_val |= MT8189_CTRL0_TXC_OUT_OP_EN; + regmap_write(plat->peri_regmap, reg_offset + MT8195_PERI_ETH_CTRL0, intf_val); -- 2.55.0