Commit 7ffb791423c7 ("x86/kaslr: Reduce KASLR entropy on most x86 systems") is too narrow. ZONE_DEVICE, in general, lets any physical address be added to the direct-map. I.e. not only ACPI hotplug ranges, CXL Memory Windows, or EFI Specific Purpose Memory, but also any PCI MMIO range for the CONFIG_DEVICE_PRIVATE and CONFIG_PCI_P2PDMA cases. A potential path to recover entropy would be to walk ACPI and determine the limits for hotplug and PCI MMIO before kernel_randomize_memory(). On smaller systems that could yield some KASLR address bits. This needs additional investigation to determine if some limited ACPI table scanning can happen this early without an open coded solution like arch/x86/boot/compressed/acpi.c needs to deploy. Cc: Balbir Singh Cc: Ingo Molnar Cc: Kees Cook Cc: Bjorn Helgaas Cc: Peter Zijlstra Cc: Andy Lutomirski Cc: Logan Gunthorpe Cc: Andrew Morton Cc: David Hildenbrand Cc: Lorenzo Stoakes Cc: "Liam R. Howlett" Cc: Vlastimil Babka Cc: Mike Rapoport Cc: Suren Baghdasaryan Cc: Michal Hocko Cc: "Yasunori Gotou (Fujitsu)" Fixes: 7ffb791423c7 ("x86/kaslr: Reduce KASLR entropy on most x86 systems") Signed-off-by: Dan Williams --- drivers/pci/Kconfig | 6 ------ mm/Kconfig | 12 ++++++++---- arch/x86/mm/kaslr.c | 10 +++++----- 3 files changed, 13 insertions(+), 15 deletions(-) diff --git a/drivers/pci/Kconfig b/drivers/pci/Kconfig index f94f5d384362..47e466946bed 100644 --- a/drivers/pci/Kconfig +++ b/drivers/pci/Kconfig @@ -207,12 +207,6 @@ config PCI_P2PDMA P2P DMA transactions must be between devices behind the same root port. - Enabling this option will reduce the entropy of x86 KASLR memory - regions. For example - on a 46 bit system, the entropy goes down - from 16 bits to 15 bits. The actual reduction in entropy depends - on the physical address bits, on processor features, kernel config - (5 level page table) and physical memory present on the system. - If unsure, say N. config PCI_LABEL diff --git a/mm/Kconfig b/mm/Kconfig index 0e26f4fc8717..d17ebcc1a029 100644 --- a/mm/Kconfig +++ b/mm/Kconfig @@ -1128,10 +1128,14 @@ config ZONE_DEVICE Device memory hotplug support allows for establishing pmem, or other device driver discovered memory regions, in the memmap. This allows pfn_to_page() lookups of otherwise - "device-physical" addresses which is needed for using a DAX - mapping in an O_DIRECT operation, among other things. - - If FS_DAX is enabled, then say Y. + "device-physical" addresses which is needed for DAX, PCI_P2PDMA, and + DEVICE_PRIVATE features among others. + + Enabling this option will reduce the entropy of x86 KASLR memory + regions. For example - on a 46 bit system, the entropy goes down + from 16 bits to 15 bits. The actual reduction in entropy depends + on the physical address bits, on processor features, kernel config + (5 level page table) and physical memory present on the system. # # Helpers to mirror range of the CPU page tables of a process into device page diff --git a/arch/x86/mm/kaslr.c b/arch/x86/mm/kaslr.c index 3c306de52fd4..834641c6049a 100644 --- a/arch/x86/mm/kaslr.c +++ b/arch/x86/mm/kaslr.c @@ -115,12 +115,12 @@ void __init kernel_randomize_memory(void) /* * Adapt physical memory region size based on available memory, - * except when CONFIG_PCI_P2PDMA is enabled. P2PDMA exposes the - * device BAR space assuming the direct map space is large enough - * for creating a ZONE_DEVICE mapping in the direct map corresponding - * to the physical BAR address. + * except when CONFIG_ZONE_DEVICE is enabled. ZONE_DEVICE wants to map + * any physical address into the direct-map. KASLR wants to reliably + * steal some physical address bits. Those design choices are in direct + * conflict. */ - if (!IS_ENABLED(CONFIG_PCI_P2PDMA) && (memory_tb < kaslr_regions[0].size_tb)) + if (!IS_ENABLED(CONFIG_ZONE_DEVICE) && (memory_tb < kaslr_regions[0].size_tb)) kaslr_regions[0].size_tb = memory_tb; /* base-commit: 6146a0f1dfae5d37442a9ddcba012add260bceb0 -- 2.51.0