The SoC brings its ethernet interface out on bank Z, but no pin groups were described, so a board had no way to hand those pins over to the MAC. Describe them as the two sets a board actually needs: the nine pins the interface always uses, and the five extra ones RGMII adds for its wider data path. Assisted-by: LLM Reviewed-by: Neil Armstrong Signed-off-by: Lucas Tanure --- arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi | 30 +++++++++++++++++++++ 1 file changed, 30 insertions(+) diff --git a/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi b/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi index 6894c06a836b..7bd53ec16607 100644 --- a/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi +++ b/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi @@ -376,6 +376,36 @@ mux { }; }; + eth_pins: eth { + mux { + groups = "eth_mdio", + "eth_mdc", + "eth_rgmii_rx_clk", + "eth_rx_dv", + "eth_rxd0", + "eth_rxd1", + "eth_txen", + "eth_txd0", + "eth_txd1"; + function = "eth"; + drive-strength-microamp = <4000>; + bias-disable; + }; + }; + + eth_rgmii_pins: eth-rgmii { + mux { + groups = "eth_rxd2_rgmii", + "eth_rxd3_rgmii", + "eth_rgmii_tx_clk", + "eth_txd2_rgmii", + "eth_txd3_rgmii"; + function = "eth"; + drive-strength-microamp = <4000>; + bias-disable; + }; + }; + i2c0_ao_d_pins: i2c0-ao-d { mux { groups = "i2c0_ao_sck_d", -- 2.56.0