The stmmac_rx function would previously set skb->ip_summed to CHECKSUM_UNNECESSARY if hardware checksum offload (CoE) was enabled and the packet was of a known IP ethertype. However, this logic failed to check if the hardware had actually reported a checksum error. The hardware status, indicating a header or payload checksum failure, was being ignored at this stage. This could cause corrupt packets to be passed up the network stack as valid. This patch corrects the logic by checking the `csum_none` status flag, which is set when the hardware reports a checksum error. If this flag is set, skb->ip_summed is now correctly set to CHECKSUM_NONE, ensuring the kernel's network stack will perform its own validation and properly handle the corrupt packet. Signed-off-by: Oleksij Rempel --- drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index 9a77390b7f9d..75d8d8042316 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -5733,7 +5733,8 @@ static int stmmac_rx(struct stmmac_priv *priv, int limit, u32 queue) skb->protocol = eth_type_trans(skb, priv->dev); - if (unlikely(!coe) || !stmmac_has_ip_ethertype(skb)) + if (unlikely(!coe) || !stmmac_has_ip_ethertype(skb) || + (status & csum_none)) skb_checksum_none_assert(skb); else skb->ip_summed = CHECKSUM_UNNECESSARY; -- 2.39.5