qca8k_bulk_read() is the regmap read op. When the Ethernet management path is not available it falls back to reading the registers one by one over MDIO, but it stores register i at val_buf + i with val_buf a void pointer: the words land one byte apart and overwrite each other, and the last six bytes of a three-register read are never written. Every multi-register read over MDIO is garbage then. qca8k_fdb_read() reads the three ATU registers this way, so the FDB dump shows MAC addresses made of the VID and the aging field, the search reads a wrong status and port mask for the entry it found, and qca8k_port_mdb_add() and qca8k_port_mdb_del() write that port mask back into the ATU. With tag_qca the management frames carry these reads and the fallback is rarely taken; it is taken every time when the management conduit is down, when a management read fails, and on boards whose CPU port is not port 0, where qca8k_conduit_change() never sets up the management conduit. Store each register in its own u32. The bug was found while bringing up a tagger without management frames; an LLM assistant (Claude, claude-fable-5-1) helped write the fix and this description. I reviewed both and tested the fix on a QCA8337 behind an IPQ5018 (GL.iNet GL-B3000), where bridge fdb show returns the right entries with it and garbage without. Fixes: c766e077d927 ("net: dsa: qca8k: convert to regmap read/write API") Signed-off-by: Stanislaw Pal --- drivers/net/dsa/qca/qca8k-8xxx.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/net/dsa/qca/qca8k-8xxx.c b/drivers/net/dsa/qca/qca8k-8xxx.c index 382753bcc4..3c8044a4d1 100644 --- a/drivers/net/dsa/qca/qca8k-8xxx.c +++ b/drivers/net/dsa/qca/qca8k-8xxx.c @@ -519,7 +519,7 @@ qca8k_bulk_read(void *ctx, const void *reg_buf, size_t reg_len, /* loop count times and increment reg of 4 */ for (i = 0; i < count; i++, reg += sizeof(u32)) { - ret = qca8k_read_mii(priv, reg, val_buf + i); + ret = qca8k_read_mii(priv, reg, (u32 *)val_buf + i); if (ret < 0) return ret; } -- 2.43.0