From: Conor Dooley The GEM IP has two methods for modifying the ptp timer. The first of these, named "increment mode", relies on software controlling the timer by setting tsu_timer_incr and tsu_timer_incr_sub_nsec and performing once-off adjustments via the tsu_timer_adjust register. This is what the macb driver uses. The second mechanism, "timer adjust mode" uses the gem_tsu_inc_ctrl and gem_tsu_ms signals to control the timer. These modes are not intended to be used in parallel, but both can be possible on the same device and which mode is used cannot be determined from the compatible on all devices, because some users of the GEM IP are SoC FPGAs that permit configuring how the IP is wired up. Add a property to indicate that gem_tsu_inc_ctrl and gem_tsu_ms are wired up for timer adjust mode. Signed-off-by: Conor Dooley --- .../devicetree/bindings/net/cdns,macb.yaml | 15 +++++++++++++++ 1 file changed, 15 insertions(+) diff --git a/Documentation/devicetree/bindings/net/cdns,macb.yaml b/Documentation/devicetree/bindings/net/cdns,macb.yaml index cb14c35ba9969..292279499d9e6 100644 --- a/Documentation/devicetree/bindings/net/cdns,macb.yaml +++ b/Documentation/devicetree/bindings/net/cdns,macb.yaml @@ -120,6 +120,12 @@ properties: power-domains: maxItems: 1 + cdns,timer-adjust: + type: boolean + description: + Set when the hardware is operating in timer-adjust mode, where the timer + is controlled by the gem_tsu_inc_ctrl and gem_tsu_ms inputs. + cdns,refclk-ext: type: boolean description: @@ -186,6 +192,15 @@ allOf: properties: reg: maxItems: 1 + - if: + not: + properties: + compatible: + contains: + const: microchip,mpfs-macb + then: + properties: + cdns,timer-adjust: false - if: properties: -- 2.51.0