dwmac-qcom-ethqos supports SGMII and 2500BASE-X using the integrated PCS, so we need to expand the PCS support to include support for BASE-X modes. Add support to the prereset configuration to detect 2500BASE-X, and arrange for stmmac_mac_select_pcs() to return the integrated PCS if its supported_interfaces bitmap reports support for the interface mode. This results in priv->hw->pcs now being write-only, so remove it. Signed-off-by: Russell King (Oracle) --- drivers/net/ethernet/stmicro/stmmac/common.h | 1 - drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++------ 2 files changed, 2 insertions(+), 7 deletions(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/common.h b/drivers/net/ethernet/stmicro/stmmac/common.h index 49df46be3669..8ef54f6e78f6 100644 --- a/drivers/net/ethernet/stmicro/stmmac/common.h +++ b/drivers/net/ethernet/stmicro/stmmac/common.h @@ -629,7 +629,6 @@ struct mac_device_info { unsigned int unicast_filter_entries; unsigned int mcast_bits_log2; unsigned int rx_csum; - unsigned int pcs; unsigned int xlgmac; unsigned int num_vlan; u32 vlan_filter[32]; diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index 5254d9d19ffe..a63ae6c4bc8a 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -911,11 +911,8 @@ static struct phylink_pcs *stmmac_mac_select_pcs(struct phylink_config *config, return pcs; } - /* The PCS control register is only relevant for SGMII, TBI and RTBI - * modes. We no longer support TBI or RTBI, so only configure this - * register when operating in SGMII mode with the integrated PCS. - */ - if (priv->hw->pcs & STMMAC_PCS_SGMII && priv->integrated_pcs) + if (priv->integrated_pcs && + test_bit(interface, priv->integrated_pcs->pcs.supported_interfaces)) return &priv->integrated_pcs->pcs; return NULL; @@ -1173,7 +1170,6 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv) if (priv->dma_cap.pcs && interface == PHY_INTERFACE_MODE_SGMII) { netdev_dbg(priv->dev, "PCS SGMII support enabled\n"); - priv->hw->pcs = STMMAC_PCS_SGMII; switch (speed) { case SPEED_10: -- 2.47.3