The call to phy_set_mode_ext() after phy_power_on() was a work-around for the qcom-sgmii-eth SerDes driver that only re-enabled its clocks on phy_power_on() but did not configure the PHY. Now that the SerDes driver fully configures the SerDes at phy_power_on(), there is no need to call phy_set_mode_ext() immediately afterwards. This also means we no longer need to record the previous operating mode of the driver - this is up to the SerDes driver. In any case, the only thing that we care about is the SerDes provides the necessary clocks to the stmmac core to allow it to reset at this point. The actual mode is irrelevant at this point as the correct mode will be configured in ethqos_mac_finish_serdes() just before the network device is brought online. Reviewed-by: Mohd Ayaan Anwar Tested-by: Mohd Ayaan Anwar Signed-off-by: Russell King (Oracle) --- .../stmicro/stmmac/dwmac-qcom-ethqos.c | 18 ++---------------- 1 file changed, 2 insertions(+), 16 deletions(-) diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c index 8913f6f02b9e..cb1c074c2053 100644 --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c @@ -105,7 +105,6 @@ struct qcom_ethqos { struct clk *link_clk; struct phy *serdes_phy; - phy_interface_t serdes_mode; phy_interface_t phy_mode; const struct ethqos_emac_por *rgmii_por; @@ -648,17 +647,8 @@ static int qcom_ethqos_serdes_powerup(struct net_device *ndev, void *priv) return ret; ret = phy_power_on(ethqos->serdes_phy); - if (ret) { - phy_exit(ethqos->serdes_phy); - return ret; - } - - ret = phy_set_mode_ext(ethqos->serdes_phy, PHY_MODE_ETHERNET, - ethqos->serdes_mode); - if (ret) { - phy_power_off(ethqos->serdes_phy); + if (ret) phy_exit(ethqos->serdes_phy); - } return ret; } @@ -681,12 +671,9 @@ static int ethqos_mac_finish_serdes(struct net_device *ndev, void *priv, qcom_ethqos_set_sgmii_loopback(ethqos, false); if (interface == PHY_INTERFACE_MODE_SGMII || - interface == PHY_INTERFACE_MODE_2500BASEX) { + interface == PHY_INTERFACE_MODE_2500BASEX) ret = phy_set_mode_ext(ethqos->serdes_phy, PHY_MODE_ETHERNET, interface); - if (ret == 0) - ethqos->serdes_mode = interface; - } return ret; } @@ -839,7 +826,6 @@ static int qcom_ethqos_probe(struct platform_device *pdev) plat_dat->host_dma_width = data->dma_addr_width; if (ethqos->serdes_phy) { - ethqos->serdes_mode = PHY_INTERFACE_MODE_SGMII; plat_dat->serdes_powerup = qcom_ethqos_serdes_powerup; plat_dat->serdes_powerdown = qcom_ethqos_serdes_powerdown; } -- 2.47.3