To adapt to new firmware for AML devices, the driver should send the
"SET_LINK_CMD" to the firmware only once when switching PHY interface
mode, and no longer needs to re-trigger PHY configuration based on the
RX signal interrupt (TXGBE_GPIOBIT_3).

In previous firmware versions, the PHY was configured only after receiving
"SET_LINK_CMD", and might remain incomplete if the RX signal was lost.
To handle this case, the driver used TXGBE_GPIOBIT_3 interrupt to resend
the command. This workaround is no longer necessary with the new firmware.

And the unknown link speed is permitted in the mailbox buffer.

Signed-off-by: Jiawen Wu <jiawenwu@trustnetic.com>
---
 drivers/net/ethernet/wangxun/libwx/wx_type.h  |  2 -
 .../net/ethernet/wangxun/txgbe/txgbe_aml.c    | 50 ++++++-------------
 .../net/ethernet/wangxun/txgbe/txgbe_type.h   |  1 +
 3 files changed, 15 insertions(+), 38 deletions(-)

diff --git a/drivers/net/ethernet/wangxun/libwx/wx_type.h b/drivers/net/ethernet/wangxun/libwx/wx_type.h
index d89b9b8a0a2c..4880268b620e 100644
--- a/drivers/net/ethernet/wangxun/libwx/wx_type.h
+++ b/drivers/net/ethernet/wangxun/libwx/wx_type.h
@@ -1271,8 +1271,6 @@ struct wx {
 
 	/* PHY stuff */
 	bool notify_down;
-	int adv_speed;
-	int adv_duplex;
 	unsigned int link;
 	int speed;
 	int duplex;
diff --git a/drivers/net/ethernet/wangxun/txgbe/txgbe_aml.c b/drivers/net/ethernet/wangxun/txgbe/txgbe_aml.c
index dc87ccad9652..1da92431c324 100644
--- a/drivers/net/ethernet/wangxun/txgbe/txgbe_aml.c
+++ b/drivers/net/ethernet/wangxun/txgbe/txgbe_aml.c
@@ -19,8 +19,8 @@ void txgbe_gpio_init_aml(struct wx *wx)
 {
 	u32 status;
 
-	wr32(wx, WX_GPIO_INTTYPE_LEVEL, TXGBE_GPIOBIT_2 | TXGBE_GPIOBIT_3);
-	wr32(wx, WX_GPIO_INTEN, TXGBE_GPIOBIT_2 | TXGBE_GPIOBIT_3);
+	wr32(wx, WX_GPIO_INTTYPE_LEVEL, TXGBE_GPIOBIT_2);
+	wr32(wx, WX_GPIO_INTEN, TXGBE_GPIOBIT_2);
 
 	status = rd32(wx, WX_GPIO_INTSTATUS);
 	for (int i = 0; i < 6; i++) {
@@ -42,11 +42,6 @@ irqreturn_t txgbe_gpio_irq_handler_aml(int irq, void *data)
 		wr32(wx, WX_GPIO_EOI, TXGBE_GPIOBIT_2);
 		wx_service_event_schedule(wx);
 	}
-	if (status & TXGBE_GPIOBIT_3) {
-		set_bit(WX_FLAG_NEED_LINK_CONFIG, wx->flags);
-		wx_service_event_schedule(wx);
-		wr32(wx, WX_GPIO_EOI, TXGBE_GPIOBIT_3);
-	}
 
 	wr32(wx, WX_GPIO_INTMASK, 0);
 	return IRQ_HANDLED;
@@ -96,6 +91,9 @@ static int txgbe_set_phy_link_hostif(struct wx *wx, int speed, int autoneg, int
 	case SPEED_10000:
 		buffer.speed = TXGBE_LINK_SPEED_10GB_FULL;
 		break;
+	default:
+		buffer.speed = TXGBE_LINK_SPEED_UNKNOWN;
+		break;
 	}
 
 	buffer.fec_mode = TXGBE_PHY_FEC_AUTO;
@@ -106,19 +104,18 @@ static int txgbe_set_phy_link_hostif(struct wx *wx, int speed, int autoneg, int
 					 WX_HI_COMMAND_TIMEOUT, true);
 }
 
-static void txgbe_get_link_capabilities(struct wx *wx)
+static void txgbe_get_link_capabilities(struct wx *wx, int *speed, int *duplex)
 {
 	struct txgbe *txgbe = wx->priv;
 
 	if (test_bit(PHY_INTERFACE_MODE_25GBASER, txgbe->sfp_interfaces))
-		wx->adv_speed = SPEED_25000;
+		*speed = SPEED_25000;
 	else if (test_bit(PHY_INTERFACE_MODE_10GBASER, txgbe->sfp_interfaces))
-		wx->adv_speed = SPEED_10000;
+		*speed = SPEED_10000;
 	else
-		wx->adv_speed = SPEED_UNKNOWN;
+		*speed = SPEED_UNKNOWN;
 
-	wx->adv_duplex = wx->adv_speed == SPEED_UNKNOWN ?
-			 DUPLEX_HALF : DUPLEX_FULL;
+	*duplex = *speed == SPEED_UNKNOWN ? DUPLEX_HALF : DUPLEX_FULL;
 }
 
 static void txgbe_get_phy_link(struct wx *wx, int *speed)
@@ -138,23 +135,11 @@ static void txgbe_get_phy_link(struct wx *wx, int *speed)
 
 int txgbe_set_phy_link(struct wx *wx)
 {
-	int speed, err;
-	u32 gpio;
+	int speed, duplex, err;
 
-	/* Check RX signal */
-	gpio = rd32(wx, WX_GPIO_EXT);
-	if (gpio & TXGBE_GPIOBIT_3)
-		return -ENODEV;
+	txgbe_get_link_capabilities(wx, &speed, &duplex);
 
-	txgbe_get_link_capabilities(wx);
-	if (wx->adv_speed == SPEED_UNKNOWN)
-		return -ENODEV;
-
-	txgbe_get_phy_link(wx, &speed);
-	if (speed == wx->adv_speed)
-		return 0;
-
-	err = txgbe_set_phy_link_hostif(wx, wx->adv_speed, 0, wx->adv_duplex);
+	err = txgbe_set_phy_link_hostif(wx, speed, 0, duplex);
 	if (err) {
 		wx_err(wx, "Failed to setup link\n");
 		return err;
@@ -230,14 +215,7 @@ int txgbe_identify_sfp(struct wx *wx)
 		return -ENODEV;
 	}
 
-	err = txgbe_sfp_to_linkmodes(wx, id);
-	if (err)
-		return err;
-
-	if (gpio & TXGBE_GPIOBIT_3)
-		set_bit(WX_FLAG_NEED_LINK_CONFIG, wx->flags);
-
-	return 0;
+	return txgbe_sfp_to_linkmodes(wx, id);
 }
 
 void txgbe_setup_link(struct wx *wx)
diff --git a/drivers/net/ethernet/wangxun/txgbe/txgbe_type.h b/drivers/net/ethernet/wangxun/txgbe/txgbe_type.h
index 9d53c7413f7b..b9a4ba48f5b9 100644
--- a/drivers/net/ethernet/wangxun/txgbe/txgbe_type.h
+++ b/drivers/net/ethernet/wangxun/txgbe/txgbe_type.h
@@ -314,6 +314,7 @@ void txgbe_up(struct wx *wx);
 int txgbe_setup_tc(struct net_device *dev, u8 tc);
 void txgbe_do_reset(struct net_device *netdev);
 
+#define TXGBE_LINK_SPEED_UNKNOWN        0
 #define TXGBE_LINK_SPEED_10GB_FULL      4
 #define TXGBE_LINK_SPEED_25GB_FULL      0x10
 
-- 
2.48.1