The LED setup routine registered both led_sync_good and led_is_gm devices without checking the return values of led_classdev_register(). If either registration failed, the function continued silently, leaving the driver in a partially-initialized state and leaking a registered LED classdev. Add proper error handling Found by Linux Verification Center (linuxtesting.org) with SVACE. Fixes: 7d9ee2e8ff15 ("net: dsa: hellcreek: Add PTP status LEDs") Signed-off-by: Pavel Zhigulin --- drivers/net/dsa/hirschmann/hellcreek_ptp.c | 14 ++++++++++++-- 1 file changed, 12 insertions(+), 2 deletions(-) diff --git a/drivers/net/dsa/hirschmann/hellcreek_ptp.c b/drivers/net/dsa/hirschmann/hellcreek_ptp.c index bfe21f9f7dcd..cb23bea9c21b 100644 --- a/drivers/net/dsa/hirschmann/hellcreek_ptp.c +++ b/drivers/net/dsa/hirschmann/hellcreek_ptp.c @@ -376,8 +376,18 @@ static int hellcreek_led_setup(struct hellcreek *hellcreek) hellcreek_set_brightness(hellcreek, STATUS_OUT_IS_GM, 1); /* Register both leds */ - led_classdev_register(hellcreek->dev, &hellcreek->led_sync_good); - led_classdev_register(hellcreek->dev, &hellcreek->led_is_gm); + ret = led_classdev_register(hellcreek->dev, &hellcreek->led_sync_good); + if (ret) { + dev_err(hellcreek->dev, "Failed to register sync_good LED\n"); + goto out; + } + + ret = led_classdev_register(hellcreek->dev, &hellcreek->led_is_gm); + if (ret) { + dev_err(hellcreek->dev, "Failed to register is_gm LED\n"); + led_classdev_unregister(&hellcreek->led_sync_good); + goto out; + } ret = 0; -- 2.43.0