bpf_prog_test_run_skb() calls eth_type_trans() first and then uses skb->protocol to initialize sk family and address fields for the test run. For IPv4 and IPv6 packets, it may access ip_hdr(skb) or ipv6_hdr(skb) even when the provided test input only contains an Ethernet header. Reject the input earlier if the Ethernet frame carries IPv4/IPv6 EtherType but the L3 header is too short. Fold the IPv4/IPv6 header length checks into the existing protocol switch and return -EINVAL before accessing the network headers. Fixes: fa5cb548ced6 ("bpf: Setup socket family and addresses in bpf_prog_test_run_skb") Reported-by: syzbot+619b9ef527f510a57cfc@syzkaller.appspotmail.com Closes: https://syzkaller.appspot.com/bug?extid=619b9ef527f510a57cfc Signed-off-by: Sun Jian --- net/bpf/test_run.c | 20 ++++++++++++-------- 1 file changed, 12 insertions(+), 8 deletions(-) diff --git a/net/bpf/test_run.c b/net/bpf/test_run.c index 178c4738e63b..300e2bfc5a62 100644 --- a/net/bpf/test_run.c +++ b/net/bpf/test_run.c @@ -1120,19 +1120,23 @@ int bpf_prog_test_run_skb(struct bpf_prog *prog, const union bpf_attr *kattr, switch (skb->protocol) { case htons(ETH_P_IP): - sk->sk_family = AF_INET; - if (sizeof(struct iphdr) <= skb_headlen(skb)) { - sk->sk_rcv_saddr = ip_hdr(skb)->saddr; - sk->sk_daddr = ip_hdr(skb)->daddr; + if (skb_headlen(skb) < sizeof(struct iphdr)) { + ret = -EINVAL; + goto out; } + sk->sk_family = AF_INET; + sk->sk_rcv_saddr = ip_hdr(skb)->saddr; + sk->sk_daddr = ip_hdr(skb)->daddr; break; #if IS_ENABLED(CONFIG_IPV6) case htons(ETH_P_IPV6): - sk->sk_family = AF_INET6; - if (sizeof(struct ipv6hdr) <= skb_headlen(skb)) { - sk->sk_v6_rcv_saddr = ipv6_hdr(skb)->saddr; - sk->sk_v6_daddr = ipv6_hdr(skb)->daddr; + if (skb_headlen(skb) < sizeof(struct ipv6hdr)) { + ret = -EINVAL; + goto out; } + sk->sk_family = AF_INET6; + sk->sk_v6_rcv_saddr = ipv6_hdr(skb)->saddr; + sk->sk_v6_daddr = ipv6_hdr(skb)->daddr; break; #endif default: -- 2.43.0