From: Li Li Currently, in idpf_wait_for_sw_marker_completion(), when an IDPF_TXD_COMPLT_SW_MARKER packet is found, the routine breaks out of the for loop and does not increment the next_to_clean counter. This causes the subsequent NAPI polls to run into the same IDPF_TXD_COMPLT_SW_MARKER packet again and print out the following: [ 23.261341] idpf 0000:05:00.0 eth1: Unknown TX completion type: 5 Instead, we should increment next_to_clean regardless when an IDPF_TXD_COMPLT_SW_MARKER packet is found. Tested: with the patch applied, we do not see the errors above from NAPI polls anymore. Fixes: 9d39447051a0 ("idpf: remove SW marker handling from NAPI") Signed-off-by: Li Li Reviewed-by: Aleksandr Loktionov Signed-off-by: Tony Nguyen --- drivers/net/ethernet/intel/idpf/idpf_txrx.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/net/ethernet/intel/idpf/idpf_txrx.c b/drivers/net/ethernet/intel/idpf/idpf_txrx.c index 376050308b06..761a77510467 100644 --- a/drivers/net/ethernet/intel/idpf/idpf_txrx.c +++ b/drivers/net/ethernet/intel/idpf/idpf_txrx.c @@ -2348,7 +2348,7 @@ void idpf_wait_for_sw_marker_completion(const struct idpf_tx_queue *txq) do { struct idpf_splitq_4b_tx_compl_desc *tx_desc; - struct idpf_tx_queue *target; + struct idpf_tx_queue *target = NULL; u32 ctype_gen, id; tx_desc = flow ? &complq->comp[ntc].common : @@ -2368,14 +2368,14 @@ void idpf_wait_for_sw_marker_completion(const struct idpf_tx_queue *txq) target = complq->txq_grp->txqs[id]; idpf_queue_clear(SW_MARKER, target); - if (target == txq) - break; next: if (unlikely(++ntc == complq->desc_count)) { ntc = 0; gen_flag = !gen_flag; } + if (target == txq) + break; } while (time_before(jiffies, timeout)); idpf_queue_assign(GEN_CHK, complq, gen_flag); -- 2.47.1