On soft-reboot, with a reset GPIO defined for an Aeonsemi PHY, the special match_phy_device fails to correctly identify that the PHY needs to load the firmware again. This is caused by the fact that PHY ID is read BEFORE the PHY reset GPIO (if present) is asserted, so we can be in the scenario where the phydev have the previous PHY ID (with the PHY firmware loaded) but after reset the generic AS21xxx PHY is present in the PHY ID registers. To better handle this, skip reading the PHY ID register only for the PHY that are not AS21xxx (by matching for the Aeonsemi Vendor) and always read the PHY ID for the other case to handle both firmware already loaded or an HW reset. Fixes: 830877d89edc ("net: phy: Add support for Aeonsemi AS21xxx PHYs") Signed-off-by: Christian Marangi --- drivers/net/phy/as21xxx.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) diff --git a/drivers/net/phy/as21xxx.c b/drivers/net/phy/as21xxx.c index 92697f43087d..005277360656 100644 --- a/drivers/net/phy/as21xxx.c +++ b/drivers/net/phy/as21xxx.c @@ -884,11 +884,12 @@ static int as21xxx_match_phy_device(struct phy_device *phydev, u32 phy_id; int ret; - /* Skip PHY that are not AS21xxx or already have firmware loaded */ - if (phydev->c45_ids.device_ids[MDIO_MMD_PCS] != PHY_ID_AS21XXX) + /* Skip PHY that are not AS21xxx */ + if (!phy_id_compare_vendor(phydev->c45_ids.device_ids[MDIO_MMD_PCS], + PHY_VENDOR_AEONSEMI)) return genphy_match_phy_device(phydev, phydrv); - /* Read PHY ID to handle firmware just loaded */ + /* Read PHY ID to handle firmware loaded or HW reset */ ret = phy_read_mmd(phydev, MDIO_MMD_PCS, MII_PHYSID1); if (ret < 0) return ret; -- 2.50.0