state->an_enabled was removed before, but is left in mac_config() doc, so clean it. Fixes: 4ee9b0dcf09f ("net: phylink: remove an_enabled") Signed-off-by: David Yang --- include/linux/phylink.h | 7 +++---- 1 file changed, 3 insertions(+), 4 deletions(-) diff --git a/include/linux/phylink.h b/include/linux/phylink.h index 30659b615fca..9af0411761d7 100644 --- a/include/linux/phylink.h +++ b/include/linux/phylink.h @@ -320,9 +320,8 @@ int mac_prepare(struct phylink_config *config, unsigned int mode, * If in 802.3z mode, the link speed is fixed, dependent on the * @state->interface. Duplex and pause modes are negotiated via * the in-band configuration word. Advertised pause modes are set - * according to the @state->an_enabled and @state->advertising - * flags. Beware of MACs which only support full duplex at gigabit - * and higher speeds. + * according to @state->advertising. Beware of MACs which only + * support full duplex at gigabit and higher speeds. * * If in Cisco SGMII mode, the link speed and duplex mode are passed * in the serial bitstream 16-bit configuration word, and the MAC @@ -331,7 +330,7 @@ int mac_prepare(struct phylink_config *config, unsigned int mode, * responsible for reading the configuration word and configuring * itself accordingly. * - * Valid state members: interface, an_enabled, pause, advertising. + * Valid state members: interface, pause, advertising. * * Implementations are expected to update the MAC to reflect the * requested settings - i.o.w., if nothing has changed between two -- 2.50.1